Do you know how to use colloid mill?

1, completely disinfection, cleaning the body inside.

2, connected to the cooling water, start the colloid mill waiting for normal operation immediately after feeding into the material processing. Idle can not be greater than 15 seconds.

3, processing materials are not allowed to have quartz, broken glass, metal crushed hard material mixed into them, otherwise the grinding will damage the movement, static grinding film.

4, pay attention to the motor load, if found to reduce the load overload.

5, colloid grinding is a high-precision machinery, grinding film gap is very small, high speed, the operator should adhere to the post, according to regulations, and found a timely shutdown, troubleshooting and then use.

6, colloid mill after use, should be thoroughly cleaned do not make the material residue machine, so as not to mechanical seal adhesion caused by leakage.

7, connected to a good hopper or feed pipe, and the discharge port, or discharge cycle tube. Connect the cooling water pipes and drain pipes.

8, installed power starter, coupled with ammeter and indicator light. Connected to the power supply, should start to determine the motor running from the inlet to see the direction should be clockwise.

9, adjust the grinding gap, the two handles loose and then clockwise rotation adjustment ring, with one hand into the base of the square inside the motor fan, when the rotation ring to feel a little friction immediately stop. And then reverse the adjustment ring a little so that the grinding gap is greater than the alignment of the number, generally in the processing of materials to meet the requirements of the fineness of the situation, as far as possible to make the gap pin larger. This will make the grinding life longer. And then clockwise tighten the handle to lock the adjustment ring, so that grinding gap fixed.