Application Method of Sunflower Seeds Butter Grinding Machine:

1, thoroughly disinfection, cleaning the body inside

2, connect the cooling water, start the colloid mill to be in normal operation immediately after feeding in grinding. Running empty of not more than 15 seconds. 3, the processing material does not allow quartz, broken glass, metal scraps of hard material mixed with them, otherwise it will damage the grinding dynamic, static grinding.

4, pay attention to the motor load, if the overload is found, the feed should be reduced

5, the colloid mill belongs to high precision machinery, plate gap is small, the running speed is high and the operator should keep the post, according to rules and operation, find fault and stop, then after troubleshooting.

6, the use of colloid mill, should be thoroughly cleaned, not to remain the material in the machine, so as to avoid mechanical seal bonding leakage

7, connect the feed hopper or feed pipe, and the discharge port, or the discharge cycle pipe. Connect the cooling water pipe and drain pipe

8, install the power starter, match the ammeter and the indicator lamp. After the power supply, the motor should be turned on to judge the motor steering, and the direction should be clockwise from the feed port

9, adjust the plate gap, then unscrew the two handle clockwise rotation adjustment ring, with one hand extends into the base square rotation of motor fan, immediately stop when the rotating ring feels a bit. Then reverse friction ring a little make grinding gap is larger than the general situation in the digital alignment, meet the processing requirements of the fineness of the material as far as possible, the grinding clearance pin is large. This can make grinding and long service life. And then clockwise handle locking adjusting ring, the fixed plate gap.